Ming RenBroker · RE/MAX Realtron Realty Inc., Brokerage
☎ 647-779-9186

Living & Communities

Switching from oil to gas in Ontario: which step comes first, and why the tank comes last for nobody

By , Broker, RE/MAX Realtron Realty Inc. (About Ming) · Published

Ming Ren · Broker · RE/MAX Realtron Realty Inc., Brokerage

← All articles · Living & Communities · Category guide

I am Ming Ren, a Broker with RE/MAX Realtron.

Here is the plain conclusion first: whether an oil-to-gas conversion is even possible turns on one question — is there a natural gas line on your street? And the step you cannot defer or cut corners on is dealing with the old oil tank properly. As for rebates, be clear about this up front: the large heating rebates in Ontario today are for heat pumps, not gas furnaces. If you budget a gas conversion assuming a large rebate will come back, that math will most likely disappoint you.

This article covers three things only: the order of the connection process, the rules for the tank, and how to add up the money. I am not quoting market prices, because line distance, ductwork and tank location vary too much from house to house; the numbers below are labelled illustrative examples, and your real figures have to come from written quotes for your own home.

First: the connection runs in order, and the contractor is the entry point

Enbridge Gas sets out the connection sequence plainly: start with a local heating contractor, who assesses your existing equipment, gives you an estimate and submits the service application on your behalf. You then receive a confirmation email asking you to confirm the service address and billing information and to acknowledge charges that may apply, such as an expansion surcharge. After Enbridge Gas installs the service, your contractor installs or converts your natural gas equipment. Finally, your contractor arranges an appointment with Enbridge Gas, and the new equipment is inspected and activated in accordance with the Technical Standards and Safety Act.

Two details deserve attention. First, the people doing gas work must hold the right credentials: the company must be a TSSA-registered fuels contractor, and the person doing the work must hold a TSSA gas technician certificate — for a typical residential furnace, that is generally the G2 or G1 level. Ask to see the company's TSSA registration number and the technician's certificate before you sign. That is not distrust; it is the rule. Second, if there is no gas on your street, the situation is entirely different: that goes through Enbridge's community expansion or feasibility process first, and neither the timing nor any shared costs are set by one household. Do not remove your oil heat or order a furnace before you know the line can actually reach you.

Permits split along a different line. Gas safety sits with TSSA, while a building permit, if one is needed, comes from your municipality — and municipalities do not all answer the same way. Toronto, for example, has a stand-alone mechanical (HVAC) permit category, while other municipalities treat a like-for-like furnace replacement differently. So the right question is not "does an oil-to-gas conversion need a permit?" but rather: have the contractor state in the written quote whether this job needs a building permit in your municipality, who applies for it, and who books the inspections. A permit promise that is not in the quote is not a promise.

Second: an out-of-service tank is not finished business

The tank carries the heaviest responsibility in the whole project, and TSSA's position is firm:

Item The rule Who does it
An unused underground tank Ontario regulations require it to be removed; it cannot simply be left in the ground Only a TSSA-registered petroleum contractor may remove it
Abandoning a tank in place Possible only with a TSSA variance, supported by an Environmental Assessment Report as required Apply first, work second — never the other way round
Tank removal or site closure An Environmental Assessment Report must be submitted under TSSA's environmental management requirements Completed by a qualified person
A spill or leak is found Report it promptly to Ontario's Spills Action Centre at 1-800-268-6060 The owner should not delay, and should not quietly clean it up first

An above-ground tank is simpler to deal with, but it still has to be emptied, disconnected and removed by qualified people, with the paperwork kept. When you later sell, what buyers and insurers usually ask is not "did you switch to gas?" but "was the old tank removed, who removed it, and is there a report?" That file is your answer — collect it on the day of the work, not years later.

One rule for homes still on oil is worth knowing: under section 7 of O. Reg. 213/01, a fuel oil distributor may supply oil only if it is satisfied the installation complies and it has inspected the appliance or work within the previous 10 years, or under an approved quality assurance inspection program. In plain terms, if an oil system has gone a long time without that comprehensive inspection, the distributor can lawfully refuse to deliver. That is also why the inspection record is one of the first things to ask about when buying an oil-heated home.

Third: count the money in three parts, and look at the heat pump line for rebates

I suggest splitting the total into three parts at the quoting stage, instead of looking at one lump sum:

Part What it covers How to check it
Connection Service line, meter, and any expansion surcharge or length-related charges that apply The Enbridge confirmation email and the application terms
Equipment and installation Gas furnace or boiler, conversion work, duct and venting changes, municipal permit if needed A written contractor quote stating who handles the permit
Tank work Emptying, removal, backfill, and any environmental assessment report A separate quote and separate paperwork from a TSSA-registered petroleum contractor

An illustrative example only, to show how the addition works — these are not anyone's prices: suppose the connection charges for a given home were an illustrative $0, the equipment quote an illustrative $6,500, and removal of an above-ground tank an illustrative $1,200. The budget to prepare would be $7,700 plus tax and a contingency, not just the $6,500 furnace figure. A buried tank involving excavation and an environmental report lands very differently, so do not set your total budget until that quote is in hand.

On rebates, under the current Home Renovation Savings program — delivered jointly by Enbridge Gas and Save on Energy — heat pump rebates are calculated per ton: for homes primarily heated with electricity, oil, propane or wood, a cold-climate air-source heat pump can reach up to $7,500 and a ground-source heat pump up to $12,000, provided the home qualifies, a participating contractor is used, and written pre-approval is obtained before installation. A gas furnace does not sit inside that heat pump rebate logic. So the real choice is between two paths: if you want simple operation and an available gas connection, go with gas — but do not count a rebate into the return; if the rebate is what motivates you, compare a heat pump seriously, and put the pre-approval step before you sign anything. Program terms change, so re-check your home's eligibility on the official program pages before committing.

On insurance and resale, I will say one plain thing: a tank removed cleanly, with complete paperwork, removes a whole set of questions a buyer would otherwise ask. A tank still in the ground with no documents invites the buyer to price in the worst case. That is not a scare tactic; it is what happens at the negotiating table every day.

Three common misunderstandings

Misunderstanding one: "Switch to gas and the government pays a large rebate." Under the current official program, the large amounts attach to heat pumps, and they require pre-approval and a participating contractor. Do not put a rebate into the gas furnace column and then go looking for a program to match it.

Misunderstanding two: "The tank is out of use, so it can stay in the ground." No. An unused underground tank must be removed under the regulations. Leaving it in place is the exception, requiring a TSSA variance and an environmental assessment report — not a contractor's verbal assurance that it is fine.

Misunderstanding three: "Any HVAC company can remove the tank and hook up the gas." Gas installation and tank removal are two separate credentials: the first calls for a TSSA-registered fuels contractor and a certified gas technician, the second for a TSSA-registered petroleum contractor. Whether one company can do both has to be checked separately for each.

If you plan to convert this year, I suggest this order

  1. Confirm with Enbridge whether natural gas service is already available at your address; if it is not, ask about expansion feasibility and timing before removing anything.
  2. Get an on-site quote from a TSSA-registered heating contractor, and require the quote to state the equipment, who handles any permit, and how inspections are booked; check the company's registration number and the technician's certificate.
  3. Get a separate quote for the old tank from a TSSA-registered petroleum contractor; for a buried tank, ask whether removal, backfill and the environmental assessment report are all included.
  4. If you are considering the heat pump rebate, verify eligibility on the official Home Renovation Savings pages and have a participating contractor submit the pre-approval before installation; do not start work without it.
  5. Add the three parts separately before deciding: connection, equipment and installation, and tank work. Let none of them ride on "we will sort it out later."
  6. When the work is done, keep the full file — connection confirmation, inspection records, tank removal documents and any environmental report, and the new equipment papers — and notify your home insurer of the change in heating.

Work honestly, and do solid work. I am Ming Ren. If your home still runs on oil and you are weighing a sale or a purchase, get the tank documents and the gas connection confirmation together first, and we will go through the file line by line.


This article is general information, not legal or technical advice. Municipal permit requirements, Enbridge connection terms and rebate program eligibility vary by address and change over time; verify them with your municipality, Enbridge Gas, TSSA and the official program pages before signing.

Primary sources: TSSA fuel oil storage tank FAQs and O. Reg. 213/01 (Fuel Oil), s.7 (Ontario e-Laws); Enbridge Gas community expansion connection pages; Home Renovation Savings (Enbridge Gas / Save on Energy) heat pump rebate pages; City of Toronto stand-alone mechanical (HVAC) permit page (all consulted November 2026). The $6,500, $1,200 and $7,700 figures are an illustrative example, not real quotes.

Frequently asked questions

Will the government pay a large rebate if I switch from oil to gas?

Under the current official program, the large amounts attach to heat pumps, and they require pre-approval and a participating contractor. Do not put a rebate into the gas furnace column and then go looking for a program to match it.

If the oil tank is no longer used, can it stay in the ground?

No. An unused underground tank must be removed under the regulations. Leaving it in place is the exception, requiring a TSSA variance and an environmental assessment report — not a contractor's verbal assurance that it is fine.

Can any HVAC company remove the tank and hook up the gas?

Gas installation and tank removal are two separate credentials: the first calls for a TSSA-registered fuels contractor and a certified gas technician, the second for a TSSA-registered petroleum contractor. Whether one company can do both has to be checked separately for each.

This article in other languages: 中文فارسی

Want to talk about your home?

You can also call directly, or scan the code to add Ming on WeChat.

Ming’s WeChat QR code
Scan to add on WeChat

Community guides by city

All cities →
☎ Call MingFree Evaluation