I am Ming Ren, a Broker with RE/MAX Realtron.
Here is the plain conclusion first: ten years old, on its own, is not a reason to replace. A properly maintained system is often not even into the second half of its life at ten years. What should decide repair versus replace is three checks — how much life is realistically left, whether this repair is worth its price, and how much the old unit's poor efficiency is costing you every month. Age is one number in that calculation, not the verdict.
One caution runs through this whole piece. The lifespan ranges and the two rules of thumb below are industry rules of thumb, not official standards, and I label them that way each time. The efficiency figures come from official sources such as NRCan and ENERGY STAR. Keep those two kinds of information separate.
Check one: how much life is left — look at failures, not just the year
The lifespan ranges the industry commonly quotes look roughly like this. These are manufacturer and trade rules of thumb, not a lifespan NRCan guarantees, and real life varies a lot with maintenance, use and installation quality:
| Equipment | Common industry lifespan range (rule of thumb) | Where ten years usually sits |
|---|---|---|
| Central air conditioner | About 15 years or longer, more with good maintenance | Usually mid-life, unless failures are frequent |
| Gas furnace | About 15–20 years | Usually mid-life |
| Heat pump | Around 15 years | Approaching the later stretch — start watching it |
So work in this order: first count how often it has failed in the last two years and whether the failures were minor parts or core components, then look at the age. Occasional small repairs — a capacitor, a cleared condensate drain — are no reason to replace even an older unit. The math changes when a core component fails, such as a compressor or a heat exchanger: those repairs are expensive, and fixing one does not make the other ageing parts any younger.
One Ontario point owners miss: if an older air conditioner uses a phased-out refrigerant, topping it up gets more expensive and harder to source every year. Which refrigerant your unit uses is on its rating plate and in its manual — ask about it before you approve any repair quote.
Check two: is this repair worth it — two heuristics, used with care
When a technician has quoted a repair and you cannot decide, the trade uses two widely repeated rules of thumb. They are useful as a first screen. Neither is an official standard, and neither is arithmetic law:
The $5,000 rule: multiply the repair quote by the unit's age; if the result is over 5,000, lean toward replacing. An invented illustrative example: a $800 repair on a 12-year-old air conditioner gives 800 × 12 = 9,600, over 5,000, so the rule leans replace. A $200 repair gives 200 × 12 = 2,400, so it leans repair.
The 50% rule: if one repair costs more than half the price of a new system, it is usually not worth doing — you have spent half the money and still own an old machine with limited remaining life and limited warranty.
Discount both rules before you use them. Neither asks how long you plan to stay in the house: someone selling in two years and someone staying twenty can get opposite answers for the same machine. Neither considers what actually failed: the $5,000 rule can point to replacement when the failed part is cheap and minor and the rest of the system is sound, in which case repairing is still sensible. Treat the rules as a first filter, then decide with the failure pattern and the efficiency check below.
Check three: efficiency — what the old unit costs you every month
Efficiency is the old unit's most concrete weakness, and here the numbers have official backing.
For air conditioners, look at SEER, the seasonal energy efficiency ratio — higher is more efficient. NRCan's EnerGuide system exists to compare exactly these ratings, and ENERGY STAR certified central air conditioners generally use less energy again than standard new models. An old unit's problem is not just its original rating: after a decade or more, dirty coils, low refrigerant and a tired blower motor push real-world efficiency below even the number on the plate. If your summer electricity bills are clearly higher than a neighbour's in a similar home, part of that gap is likely this machine.
For furnaces, look at AFUE, annual fuel utilization efficiency — the share of the fuel that actually becomes heat in your home. On NRCan's EnerGuide page, gas and propane forced-air furnaces range from 90% to 98% AFUE, with high-efficiency condensing furnaces at the top of that range. An illustrative calculation, with invented numbers, shows why the gap matters: if $2,000 of your annual gas bill goes to heating, an older furnace at 80% AFUE sends roughly $400 of it up the flue, while a 96% condensing furnace sends up roughly $80. A few hundred dollars a year becomes a few thousand over a decade — that is the case where replacing a unit that could still be repaired genuinely pays.
If you do decide to replace, there is one more step: rebates. Ontario's current Home Renovation Savings program, delivered by Enbridge Gas and Save on Energy, currently publishes its heating and cooling support mainly around heat pumps — for example, $500 per ton, up to $2,000, for a cold-climate air-source heat pump in an Enbridge gas-heated home. Amounts, eligibility and covered equipment change, and pre-approval before installation is typically required. Check the program's official site for the current terms for your home's heating fuel before you sign anything, and do not rely on an old article or a salesperson's summary. Whether a standalone gas furnace qualifies at all, and for how much, is exactly the kind of detail to confirm in the program's current wording.
Three common misunderstandings
"It's ten years old, so replacing it must pay off." No. Ten years is usually mid-life for a maintained air conditioner or furnace. Replacing a healthy unit just because it is new rarely earns its cost back in energy savings for many years.
"The $5,000 rule says replace, so I have to replace." That rule is an industry heuristic, not an NRCan or ENERGY STAR standard. It ignores whether the failed part is minor or core, and how long you plan to stay. Going over the line is a prompt to run the numbers carefully, not an order to replace.
"Repairing until it dies completely is always the cheapest path." Dying completely has two costs: the unit tends to fail mid-season, when technicians are booked out and you have to accept whatever quote you can get, and the old unit's low efficiency keeps overcharging you on every electricity and gas bill in the meantime. Near the end of a unit's life, replacing on your own schedule in the off-season beats an emergency replacement in a heat wave or a cold snap.
If a technician is quoting you tomorrow, do these five things in order
- Find the rating plate and note the brand, model and year of manufacture, then pull your repair bills from the last three years and count the failures and which parts failed.
- Make the technician itemize the quote: core component or minor part, what warranty the repair carries, and whether the unit's refrigerant is still readily available.
- Run both heuristics — repair cost times age, and repair cost as a share of a new system — as a screen only, then weigh how long you plan to stay in the house.
- Pull a year of electricity and gas bills, compare the peak summer and winter months with a similar neighbouring home, and estimate what low efficiency costs you per year.
- If you lean toward replacing, verify the current Home Renovation Savings terms and its pre-approval requirement on the official site first, then get at least two quotes and compare model, SEER or AFUE and warranty length — not just the total price.
Trust Professional, Diligent Work. I am Ming Ren. When a home you are buying or selling has an older furnace or air conditioner, get the rating-plate year and the repair history first, and we will run these three checks, one by one.
This article is general information only, not repair or engineering advice. The actual condition of your equipment, and any safety issue — especially with gas appliances — must be assessed on site by a licensed HVAC technician; the rules of thumb here are no substitute for that inspection.
Primary sources: Natural Resources Canada (NRCan) EnerGuide — Furnaces (gas/propane furnace AFUE range 90%–98%, consulted November 2026); ENERGY STAR heating and cooling efficiency guidance; Ontario Home Renovation Savings program site (Enbridge Gas / Save on Energy — rebate amounts as published there at the time of checking). Lifespan ranges, the $5,000 rule and the 50% rule are industry rules of thumb, not official standards. The $800, 12-year and $2,000 figures are illustrative examples, not real quotes.
Frequently asked questions
My furnace or AC is ten years old — does replacing it always pay off?
No. Ten years is usually mid-life for a maintained air conditioner or furnace, and replacing a healthy unit just because a new one is newer rarely earns its cost back in energy savings for many years.
The $5,000 rule says replace — do I have to replace?
That rule is an industry heuristic, not an NRCan or ENERGY STAR standard. It ignores whether the failed part is minor or core and how long you plan to stay, so going over the line is a prompt to run the numbers carefully, not an order to replace.
Is repairing until the unit dies completely always the cheapest path?
No. The unit tends to fail mid-season, when technicians are booked out and you must accept whatever quote you can get, and the old unit's low efficiency keeps overcharging you on every electricity and gas bill in the meantime.


