I am Ming Ren, a Broker with RE/MAX Realtron.
Here is the plain conclusion first: a recurring ice dam is usually not a failed roof and not just a heavy-snow year. It is warm, moist house air leaking into the attic and heating the roof from underneath. Snow melts over the warm middle of the roof, runs down to the cold eave, and refreezes there, layer upon layer, until it forms a ridge of ice. Later meltwater backs up behind that ridge, works its way under the shingles, and ends up in ceilings and walls. The fix lives in the attic, not at the eave — and the order matters: seal the air leaks first, then top up the insulation, and only then look at ventilation.
1. An ice dam is made by an uneven roof temperature
The eave overhangs the outside wall and gets no heat from the attic, so it stays cold. The trouble starts in the middle of the roof: if house air keeps leaking up through the ceiling, that part of the roof deck runs warmer than the eave. Snow melts there first, the water runs downhill, and it freezes the moment it reaches the cold edge. Repeat that cycle and the ice builds into a dam, with nowhere for the next meltwater to go except pooling behind it.
CMHC's attic guidance makes a simple point: shingles are designed to shed water running down, not water backing up. Once water ponds under them, it finds the penetrations — chimneys, plumbing vents, joints — and works inside. What you see may be a stain on the top-floor ceiling, bubbling paint in an outside corner, or a drip that only appears in spring, when a winter's worth of frost on the underside of the sheathing melts all at once. Tell an ice dam apart from a roof leak and from attic condensation before you spend anything; the three have different fixes, and new shingles fix only one of them.
2. The order is air sealing, insulation, ventilation — do not reverse it
Natural Resources Canada's Keeping the Heat In, in its roofs and attics chapter, repeats one line in several ways: the importance of air sealing cannot be overstated. The reason is basic. Insulation slows heat moving by conduction; it does not stop air itself. As long as warm, moist air can leak through the ceiling, the roof deck will keep warming and that moisture will keep frosting up in the attic, no matter how deep the insulation is.
The usual leak points all sit in the ceiling plane:
| Leak point | Why it leaks | Direction of the fix |
|---|---|---|
| Attic hatch | It is, by design, a hole in the ceiling | Weatherstrip it, and insulate the hatch lid itself |
| Pot lights, bath fans, wiring and plumbing penetrations | Each one was cut through the ceiling and left unsealed | Seal each one; every bath fan must exhaust outdoors |
| Chimney and flue chases | Gaps are left between the flue and the framing | Seal with suitable materials at proper fire clearances — a job for a pro if you are unsure |
| Tops of interior walls | Wall cavities can run straight up into the attic | Seal the top-plate joints from the attic side |
With the sealing done, look at insulation: it should be even and at full depth, especially around the perimeter directly above the outside walls, where it is most often thin or missing. Natural Resources Canada warns that uneven coverage creates cold spots on the ceiling, and the thin edge is exactly where ice dams like to start. How much your house should have is set out in official guidance by climate zone — have an inspector or insulation contractor measure what you have and what your area calls for. Do not copy a neighbour's number, and do not rely on a single figure from a product brochure.
Ventilation comes last. The soffit intake vents at the eaves and the exhaust vents up high need to be open, insulation must not block the intake, and baffles can be fitted to keep that air channel clear. But CMHC is explicit: when an attic is wet or damming, the usual instinct — add more ventilation — is the wrong approach. Before the leaks are sealed, extra venting can actually pull more warm, moist house air up into the attic and make things worse. Once air sealing is done, the existing ventilation is usually enough.
An illustrative example, with invented numbers only to show why order matters: say two households spend the same budget one winter. One adds two roof vents and nothing else. The other seals the hatch, the pot lights and every pipe penetration first. The next winter, the first house dams exactly as before; on the second house, the roof snow melts noticeably more slowly. The numbers are illustrative — the principle is what the official guidance supports: money spent stopping air leaks does more than money spent adding vents.
3. How to read this signal when buying or selling
A row of small icicles on a winter showing is not, by itself, a verdict. Occasional, modest icicles can simply be watched. But a thick dam that returns every year, together with water stains on the top-floor ceiling, bubbling paint in an outside corner, or a musty smell, deserves to be taken seriously: it usually means attic air leakage or thin insulation has been at work for more than one winter, and water may already have been inside the roof and walls.
For buyers, the move is simple: put the attic on the inspector's list by name, and ask for four things — whether the insulation is even and full-depth, whether any of it is discoloured or damp (discoloured insulation often marks an air leak below it), whether the underside of the sheathing shows water marks or frost, and whether insulation is blocking the soffit vents. For sellers, the better play is the reverse of chipping ice every January: do the air sealing and insulation in spring or fall, and keep the invoices and work records. A clean attic and clean eaves in winter are visible proof to a buyer, and they remove a round of negotiation later.
As for chipping ice, salting it, or fitting heat cables, my view matches the official guidance: those relieve a symptom, they do not touch the air leakage underneath, and chipping can damage shingles and the eave membrane. An ice-and-water membrane at the eaves is good practice when you re-roof, but it is a last line of defence, not a cure — water that ponds behind a dam every day will test any defence eventually. Fix the attic first, consider eave aids second, and never work on an icy roof yourself.
Three common misunderstandings
"The snow was just heavy. Old houses all do this — live with it." Heavy snow is a condition, not the cause. On the same street, in the same winter, a house with a sealed ceiling and full insulation keeps an evenly cold roof and does not dam the same way. A dam that returns every year is heat escaping upward, and it should not be lived with.
"Adding a few more roof vents will solve it." It will not. CMHC's guidance is clear that adding ventilation before the air leaks are sealed can draw even more warm, moist air into the attic. Ventilation is step three, not step one.
"Thicker insulation is always safer — just fill the attic." Insulation stops conduction, not air movement. Add depth without air sealing and the warm, moist air still gets up there to frost and melt — and the leaks end up buried under new insulation, harder to find later. Find and fix the moisture source and the leaks first, then insulate.
If your house dams again this winter, do these things in order
- Measure where the leak shows inside, then match that spot in the attic and check the underside of the sheathing for water marks, frost or damp — first establish whether you are dealing with an ice dam, condensation, or a roof leak.
- Do not climb onto an icy roof to chip ice, and do not use salt. If water is coming in, have a roofing company deal with the dam safely from the ground or a ladder, and keep your own photos and notes.
- Have a home inspector or attic insulation contractor go through the ceiling-plane leak points one by one: hatch, pot lights, bath fans, plumbing and wiring penetrations, the chimney chase, and interior wall tops.
- Finish the air sealing first, then top up insulation to the level the official guidance sets for your climate zone — full depth over the outside walls, with baffles keeping the soffit intake open.
- Only after sealing and insulating, assess whether ventilation is adequate. Do not start by adding vents.
- If you are about to buy or sell, list the attic as its own line item in the inspection or the work records — do not judge the house by the icicles alone.
Trust Professional, Diligent Work. I am Ming Ren. If you see ice dams and ceiling stains on a winter showing, do not rush to a conclusion — open the attic, look properly, and we will go through what the inspection actually shows, item by item.
This article is general information only, not professional building or repair advice. Your roof structure, attic type and moisture sources will affect the right treatment; consult a qualified home inspector or contractor before starting work.
Primary sources: CMHC, "Attic Venting, Attic Moisture and Ice Dams" (About Your House series); Natural Resources Canada, "Keeping the Heat In," Chapter 5, Roofs and Attics, including s.5.5 Ice Dams (consulted November 2026). The two-household budget comparison is an illustrative example, not a real case. No product prices or product insulation claims from the original article have been carried over.
Frequently asked questions
The snow was just heavy — do old houses all do this, so should I live with it?
Heavy snow is a condition, not the cause. On the same street, in the same winter, a house with a sealed ceiling and full insulation keeps an evenly cold roof and does not dam the same way; a dam that returns every year is heat escaping upward.
Will adding a few more roof vents solve ice dams?
It will not. CMHC's guidance is clear that adding ventilation before the air leaks are sealed can draw even more warm, moist air into the attic. Ventilation is step three, not step one.
Is thicker insulation always safer — just fill the attic?
Insulation stops conduction, not air movement. Add depth without air sealing and the warm, moist air still gets up there to frost and melt, and the leaks end up buried under new insulation. Find and fix the moisture source and the leaks first, then insulate.


