Ming RenBroker · RE/MAX Realtron Realty Inc., Brokerage
☎ 647-779-9186

Living & Communities

How Tall Can a Fence Be in Toronto? There Is No Single Number

By , Broker, RE/MAX Realtron Realty Inc. (About Ming) · Published

Ming Ren · Broker · RE/MAX Realtron Realty Inc., Brokerage

← All articles · Living & Communities · Category guide

I am Ming Ren, a Broker with RE/MAX Realtron.

The short answer: the most common limit for a Toronto residential fence is 2.0 metres, but that number does not travel around the whole yard. Under Table 1 in Chapter 447 of the Toronto Municipal Code, a fence in a front yard within 2.4 metres of a lot line abutting a public highway is limited to 1.2 metres. The rest of the front yard is 2.0 metres, an ordinary rear or side fence between houses is 2.0 metres, and a fence outside the front yard that abuts a multiple-residential or non-residential property, a public highway or a public walkway may reach 2.5 metres. Height is measured from the average grade one metre out on each side of the fence, and no point along the fence may exceed its limit.

So the right question is not "how tall can my fence be" but "how tall can this stretch of my fence be." Section 447-1.2 B treats each part of a fence that matches a different description in the table as a separate fence with its own maximum — which is why one fence around a corner lot can carry three or four limits at once.

First: location decides, and the front yard, corner and driveway are where people trip

Almost every row of Table 1 starts with location. On an ordinary lot, the front yard is the space between the main front wall of the building and the lot line abutting a public highway, across the full width of the lot. A corner lot is different: its front yard is measured from the shorter lot line abutting a public highway, other than a public lane. The longer street side is a side lot line abutting a public highway, and fences there fall under the table rows for that side, which also turn on distance from a driveway.

The 2.4 metres that keeps appearing in the table is not one measurement. It can mean distance from a lot line abutting a public highway in the front yard, distance from a street-facing side lot line on a corner lot, or distance from a driveway. Chapter 447 also imposes a see-through requirement near driveways, so that drivers and pedestrians can see each other. Draw the three lines on a sketch before you open the table, or you will measure from the wrong one.

Remember what counts as a fence here. Section 447-1.1 defines a fence broadly: any barrier or structure that screens, encloses or divides land or marks a boundary, and it expressly includes a hedge or shrub that does the same job. A row of cedars planted on a lot line to act as a fence is treated as one. Table 1 gives hedges their own column: 1.2 metres in the front-yard strip near the street, 2.0 metres on the corner side near a driveway, and no maximum in several other positions. No maximum for height does not mean no rules at all — the driveway visibility requirements can still apply to planting.

Second: where height is measured from, and why an old fence proves nothing

Measurement is the second trap. Under the table, height is taken at any point along the fence from the average grade level measured perpendicular to, and one metre away on either side of, the fence. Raising the ground on your side does not raise your limit, and a low side next door does not lower the measurement to your grade. On a sloped lot, the stretch that looks fine at one end can be over the limit at the other. Have the contractor record grade and fence height at several points along the line before building, not after a dispute starts.

Responsibility is broader than the name on title, too. The definition of owner in section 447-1.1 reaches managers who collect rent, tenants and persons in charge of a property, and section 447-1.2 prohibits anyone from erecting, owning or maintaining a non-complying fence, or causing or permitting one. On a rental property, both landlord and occupant can hear from the City about the same fence.

And an old fence is not proof of compliance. The current Chapter 447 was substituted by By-law 641-2018 and came into force on June 20, 2018. Whether an older fence may remain, and whether an exemption granted years ago still covers it, depends on documents and City records, not on age. When you buy a house with a conspicuously tall fence, treat "it has always been like that" as a point to verify, not an answer.

Third: the exemption route exists, but its first step is a deadline

If a fence is already built and a notice of violation arrives, Chapter 447 leaves a door open around section 447-5: the owner may apply to the local Community Council for an exemption. Municipal Licensing and Standards reviews the fence and reports, and Community Council decides. An approval can carry conditions — maintain as built, no alteration, and rebuild to the current by-law when replacement is needed. A refusal means bringing the fence into compliance.

The part to respect is timing. The application must be made by the date set out in the notice of violation. Miss that date and the options narrow sharply. So the first move on receiving a notice is not to measure the fence; it is to read the date, file the application in time, and then build the case — grade, safety, privacy and the pattern of fences nearby are facts a council can weigh, while "it does not look that tall" is not.

A clearly labelled illustrative example, with invented details: a corner-lot owner replaces a fence at a uniform 2.0 metres all the way around, then receives a notice because the front-yard stretch within 2.4 metres of the street line is limited to 1.2 metres. The workmanship was fine; the mistake was treating the whole run as one number. A location-by-location check against Table 1 before ordering materials would have flagged one short stretch.

Common misunderstandings

Misunderstanding 1: "Toronto fences are all capped at 2 metres." Two metres is only the common default. The front-yard strip near the street is 1.2 metres, and qualifying non-front-yard stretches abutting certain uses can reach 2.5 metres.

Misunderstanding 2: "Height is measured from the ground in my yard." It is measured from the average grade one metre out on each side of the fence, at every point along it.

Misunderstanding 3: "A hedge is not a fence, so it can grow freely." A hedge acting as a fence is treated as a fence under this chapter, with its own column in Table 1 and limits in the two most sensitive positions.

Misunderstanding 4: "Nobody has complained about the old fence, so it must be legal." Silence is not compliance. The current chapter dates from 2018, and the status of an old fence or an old exemption is a records question.

Before you build, or after a notice arrives, do this in order

  1. Sketch your lot: front yard, rear yard, street-facing side line and driveway, and divide the fence into stretches by location.
  2. Check each stretch against Table 1 separately — position, distance from lot lines and the driveway, fence or hedge — and write down its limit.
  3. Measure height from the average grade one metre out on each side, at several points, and pay special attention to the high end of any slope.
  4. On a corner lot, identify the shorter street line first and fix the front yard from it, rather than assuming the side with the front door governs.
  5. If a fence is already over the limit or a notice has arrived, read the notice date first and file an exemption application by that date.
  6. On a rental property, settle in writing who maintains and trims the fence, so landlord and occupant are not surprised by the same notice.

Ming Ren, Broker, RE/MAX Realtron. Bring the lot sketch and any notice you have received, and we will check the fence stretch by stretch.


This article is general information, not legal advice. Zoning, past exemptions and City records for a specific lot affect the conclusion, so confirm with Municipal Licensing and Standards before acting.

Primary sources: City of Toronto Municipal Code Chapter 447, Fences, ss.447-1.1, 447-1.2 B and Table 1, 447-5 (By-law 641-2018, in force June 20, 2018; checked November 2026). The example above is illustrative and invented.

This article in other languages: 中文فارسی

Want to talk about your home?

You can also call directly, or scan the code to add Ming on WeChat.

Ming’s WeChat QR code
Scan to add on WeChat

Community guides by city

All cities →
☎ Call MingFree Evaluation