Ming RenBroker · RE/MAX Realtron Realty Inc., Brokerage
☎ 647-779-9186

Selling a Home

After the Home Inspection, the Buyer Wants a Price Cut, a Credit, or Repairs: What an Ontario Seller Should Check First

By , Broker, RE/MAX Realtron Realty Inc. (About Ming) · Published

Ming Ren · Broker · RE/MAX Realtron Realty Inc., Brokerage

← All articles · Selling a Home · Category guide

I am Ming Ren, a Broker with RE/MAX Realtron.

The plain answer first: no clause obliges a seller to concede anything just because an inspection report exists. But before you answer, you must establish two facts — which version of the inspection condition you signed, and whether its period is still open. The same repair list is a negotiation backed by a walk-away right while the condition is alive, and a simple request you may refuse once the deal is firm. Find your position first; talk money second.

1. Which inspection condition did you sign?

OREA's clause library contains more than one way to write an inspection condition. The differences that matter to a seller:

Version What "satisfactory" means What it means for the seller
General version (the INSP-1 type) The buyer obtains a report satisfactory to the buyer, in the buyer's own discretion The buyer need not prove the defects are serious; dissatisfaction alone can end the deal
Seller-may-remedy version (the INSP-4 type) If the buyer is dissatisfied, the question becomes whether the seller is willing and able to remedy the defects in a good and workmanlike manner The seller gains a "repair instead of discount" route, but the buyer typically keeps a right to re-inspect the work
Cost-threshold version (the INSP-3 type) Satisfaction turns on whether the inspector's written estimate of total repair cost stays within a stated amount A more objective test; the fight, if any, is over the estimate

Treat that table as a map, not the territory. The clause actually inserted into your agreement is what counts — pull out the signed offer and read it, rather than relying on anyone's recollection. Note as well that an inspection condition is normally for the buyer's benefit: only the buyer can waive it or confirm it fulfilled.

2. Is the condition period still open, or is the deal firm?

This is the line that decides your bargaining position:

  • Period still open: Under the general wording, if the buyer neither confirms the condition fulfilled nor waives it in writing by the deadline, the agreement becomes null and void and the deposit is returned to the buyer in full. Refusing every request may therefore cost you the whole transaction. You are really pricing the question, "Do I still want this deal?"
  • Condition already waived in writing, deal firm: The inspection condition no longer exists, and nothing in the agreement requires you to re-price because of a report. Any further ask is voluntary negotiation; you may decline and the contract proceeds as written.
  • Time is strict: Form 100 makes time of the essence. Deadlines in the condition and in any amendment the buyer sends are read as written; an extension needs both parties' signatures, not a verbal assurance.

3. Four ways to concede — and what each one costs you

If you decide to give something, the form of the concession matters. Using an illustrative repair list estimated at $18,000:

Option How it is done Watch out for
Straight price reduction An amendment lowers the price — say by $15,000 Cleanest route, no performance to argue about later; a changed price can change related tax calculations, so have your lawyer confirm
Credit on closing Price stays, seller gives the buyer a stated credit at completion Similar economics to a price cut, but treatment by the buyer's lender, in the closing documents, and for tax can differ — both lawyers should approve the wording
Seller repairs before closing Seller completes a defined list of repairs Define the items, the standard of work, the completion date, and how the buyer verifies; vague promises are where closing-day fights start
Holdback Part of the closing funds is held back until agreed work is done State the amount, who holds it, the release conditions, and what happens if the work is not done; no Ontario statute writes these terms for you — the written agreement does

My practice: where the amount is modest and the items are clear, a price reduction or credit is usually the least troublesome. Reserve repairs and holdbacks for safety or structural items the buyer genuinely needs fixed — and if you use them, write the standard and the verification step in detail.

Three common misunderstandings

"The report gives the buyer a right to renegotiate." It does not. During the condition period the buyer's leverage is the right not to confirm the condition and let the deal die. After the deal is firm, even that leverage is gone.

"I agreed verbally to knock a bit off so they can proceed with financing." Price and term changes belong in a signed amendment. A verbal concession protects neither side and mainly manufactures a later dispute.

"If I agree to repair, 'good enough' will do." "Good enough" is where arguments live. If you promise repairs, list the items, the workmanship standard, the deadline, and the buyer's re-inspection right in writing — some clause versions give the buyer that re-inspection right already.

Before you reply to the buyer, do these in order

  1. Pull the signed agreement, copy out the inspection clause and its deadline, and confirm whether the buyer has already waived or fulfilled the condition in writing.
  2. Ask for the complete inspection report, not selected pages, and match each request against it: price cut, credit, repairs, or holdback.
  3. Get your own quotes for the items before deciding how much to give; do not simply split the buyer's numbers.
  4. Put the agreed change into a signed amendment; where a credit, holdback, or tax treatment is involved, have your lawyer review it first.
  5. Respect every written deadline — reply on time, and if you need time to price repairs, agree to an extension in writing rather than letting documents expire in silence.

Honest work, done properly. I am Ming Ren — after an inspection, open the contract before you open the calculator, and in that order.


This article is general information, not legal advice. The inspection wording in your signed agreement and the facts of your transaction will affect the result; consult an Ontario lawyer before acting.

Primary sources: Ontario Real Estate Association, Residential and Commercial Clauses (inspection clauses INSP-1, INSP-3, INSP-4) and OREA Forms 100 and 120, reviewed November 2026. The $18,000 and $15,000 figures are illustrative, not a real transaction.

Frequently asked questions

Does the inspection report give the buyer a right to renegotiate the price?

No. During the condition period the buyer's leverage is the right not to confirm the condition and let the deal die. After the deal is firm, even that leverage is gone.

Can I agree verbally to knock a bit off so the buyer can proceed with financing?

Price and term changes belong in a signed amendment. A verbal concession protects neither side and mainly manufactures a later dispute.

If I agree to do repairs, is 'good enough' good enough?

No — 'good enough' is where arguments live. If you promise repairs, list the items, the workmanship standard, the deadline, and the buyer's re-inspection right in writing.

This article in other languages: 中文فارسی

Want to talk about your home?

You can also call directly, or scan the code to add Ming on WeChat.

Ming’s WeChat QR code
Scan to add on WeChat

Community guides by city

All cities →
☎ Call MingFree Evaluation