I am Ming Ren, a Broker with RE/MAX Realtron.
The plain conclusion first: if your home touches the ground, it is worth testing for radon once. Do not guess from a so-called high-radon area, and do not borrow your neighbour's number — radon is house by house, and the only reliable answer is a long-term test of at least three months in your own home. Canada's reference level is 200 Bq/m³. At or above that level, follow Health Canada's advice and arrange mitigation — and the higher the reading, the sooner you should act.
1. What radon is, and why you cannot judge it by feel
Radon is a radioactive gas produced as uranium in soil decays naturally. It is colourless and odourless. It enters through cracks in the foundation, gaps around pipes, and basement floors, then builds up in enclosed spaces. Over years of breathing it in, radon's decay products deliver radiation to lung tissue. Health Canada identifies radon as the leading cause of lung cancer among non-smokers in Canada, and the risk is higher for people who smoke.
The key point is that radon does not track a home's age, finishes, or neighbourhood reputation. A new house can test high and an older one low; two houses side by side on the same street can read very differently. A map, a street's image, or a neighbour's one-time result cannot settle your house. Only a test in your house can.
Radon comes up from the ground, so levels are usually highest on the lowest lived-in level. A basement finished as a family room, office, or bedroom is both the closest level to the ground and often where people spend the most time — do not skip it. Upper-floor condominium units are far from the ground and generally much lower risk; ground-floor units, townhouses, and any home with a basement are the priority.
2. How to test so the result actually counts
Health Canada recommends a long-term test, not a short test that runs for a few days. Radon levels swing widely within a day and with the weather, so a few days of data can read falsely high or falsely low, and decisions made on it go wrong easily.
| Point | The right way to do it |
|---|---|
| Duration | At least 3 continuous months; a longer period gives a more trustworthy average |
| Season | Cover the heating season if you can — the fall and winter months when windows stay closed, which is closest to your real long-term exposure |
| Placement | The lowest level where you actually spend time, such as a basement family room or a ground-floor bedroom, following the kit instructions and avoiding kitchens, bathrooms, and exterior doorways |
| Tools | Use a long-term test kit yourself, or hire a C-NRPP certified measurement professional; if you use an electronic radon monitor, choose a model that has passed C-NRPP performance testing for long-term measurement |
An illustrative example, with invented timing only to show the sequence: suppose you place a kit in the basement family room in early October. Counting at least three months, you would not retrieve and mail it to the lab until early January at the soonest. Do not open it early out of curiosity or move it midway. Live normally, record the start and end dates as instructed, and send those dates back with the kit.
Buyers and sellers should do the time math carefully. A proper long-term test takes more than three months, so it usually does not fit inside an inspection condition period of a few weeks. A buyer should not expect a reliable long-term result before conditions expire; the practical approach is to test during the first heating season after moving in. If a seller already has a long-term report, ask for the original report together with its start and end dates and the floor where the device sat, then judge for yourself whether that report is usable.
3. If the result is high: keep the order straight
Once the report comes back, compare it with one number only: 200 Bq/m³, Canada's reference level. Below it, do not file the topic away forever — test again after a basement renovation, foundation work, or a heating and ventilation change. At or above it, mitigation is the next step.
Health Canada's position is that at 200 Bq/m³ or above, you should take action to reduce the level within one year, and the higher the reading, the sooner the work should be completed. Do not hire whoever happens to advertise first. Look for a mitigator certified under C-NRPP — the Canadian National Radon Proficiency Program — through the directory at c-nrpp.ca. The most common method is active soil depressurization, often called sub-slab depressurization: it creates negative pressure below the floor and uses a pipe and fan to draw radon out and vent it outdoors before it enters the home. After the work, run another long-term test and confirm from the new reading that the level actually came down. A contractor's word alone is not a finish line.
If you bought a newly built home, do not assume someone else will automatically look after mitigation for you. Pull out your purchase and warranty documents and check, item by item against Tarion's current published guidance, what radon-related coverage and claim deadlines apply to you. If anything is unclear, ask Tarion directly and keep the answer in writing. Miss one of those deadlines and you argue from a much weaker position.
A high result is not the end of the world. It is a problem with an engineering fix, and the fix is proven by a re-test number. When a purchase turns up a high reading, the sensible negotiation is for the seller to mitigate, or for the agreement to spell out the mitigation in price and terms — not panic based on a short-term reading, and not pretending the issue does not exist either.
Three common misunderstandings
"My area is not a high-radon zone, so I do not need to test." Radon is measured house by house, not assigned by zone. Two neighbouring homes can differ widely. Without a long-term reading from your own home, there is no conclusion.
"I bought a kit that tests in a few days and it read low, so I am fine." Short-term readings are too affected by weather and ventilation; low over a few days does not mean low over the long term. Health Canada calls for a long-term test of at least three months, ideally covering the heating season.
"A high result means the home cannot be bought or lived in." No. A high result calls for mitigation and a re-test, not an automatic rejection. What does not work is never testing, testing the wrong way, or sitting on a high result without acting.
If you plan to test this heating season, do these in order
- Choose the placement first: the lowest lived-in level where your household spends the most time, away from kitchens, bathrooms, laundry rooms, and spots directly facing an exterior door.
- Buy a long-term test kit, or find a C-NRPP certified measurement professional at c-nrpp.ca. For an electronic monitor, first confirm the model has passed C-NRPP long-term performance testing.
- Place the kit soon after the heating season starts, note the start date, leave it for at least three months, and do not move or open it early.
- When the period ends, retrieve and mail it exactly as instructed, and file the report with its start and end dates and placement floor. That is your home's first baseline reading.
- If the result is below 200 Bq/m³, keep the report and re-test after major renovations or foundation work. If it is at or above 200 Bq/m³, get quotes from C-NRPP certified mitigators — and do not let a higher reading wait.
- After mitigation, run a second long-term test to confirm the level is below the reference level before calling the job done. New-home buyers should also confirm their warranty coverage and deadlines with Tarion.
Trust Professional, Diligent Work. I am Ming Ren. If a radon report in a purchase or sale does not make sense to you, bring the report and its test dates, and we will go through the numbers one by one.
This article is general information only, not medical, legal, or engineering advice. Your home's testing and mitigation decisions should follow Health Canada guidance and the on-site judgement of a C-NRPP certified professional.
Primary sources: Health Canada, "Radon guideline" and its residential radon measurement guidance (canada.ca, consulted November 2026: reference level 200 Bq/m³, long-term test of at least 3 months); C-NRPP certified professional directory (c-nrpp.ca). The October-to-January timing is an illustrative example, not a real case; no local radon statistics are used in this article.
Frequently asked questions
My area is not a high-radon zone, so do I need to test?
Yes, consider testing. Radon is measured house by house, not assigned by zone, and two neighbouring homes can differ widely.
A kit that tests in a few days read low, am I fine?
Not necessarily. Short-term readings are too affected by weather and ventilation, and Health Canada calls for a long-term test of at least three months, ideally covering the heating season.
Does a high result mean the home cannot be bought or lived in?
No. A high result calls for mitigation and a re-test, not an automatic rejection.


